Cisco Systems OL-7821-04 Manual de usuario descargar pdf (Pagina 57)

Chapter 4 Installation and Maintenance

Removing and Replacing a Power Supply Unit

Cisco SCE 1000 2xGBE Installation and Configuration Guide

OL-7821-04 4-17

Replacing the Power Supply Unit

Warning

Do not mix AC-input and DC-input power supply units in the same SCE 1000 platform.

To install a new power supply into a SCE 1000 platform, complete the following steps:

Step 1 Grasp the power supply unit handle with one hand and place your other hand underneath the

power supply for support.

Step 2 Fit the groove in the side of the new power supply module into the guide in the chassis.

Step 3 Gently, but firmly, slide the module into the chassis until its faceplate is flush with the chassis rear

panel.

Warning

When inserting a power supply into the SCE 1000 platform, do not use unnecessary force; slamming

the power supply into the chassis can damage the connectors on the rear of the power supply.

Step 4 Seat the power supply in the SCE 1000 platform by tightening the captive installation screw with

a 1/4-inch flat-blade screwdriver.

Note

The power supply is not fully seated until you tighten the installation screw on the faceplate.

This completes the procedures for replacing a power supply in a SCE 1000 platform.

Reconnecting the Power

The following sections describe how to reconnect the AC or DC power:

• Reconnecting AC-Input Power Supply Unit (on page 4-18)

• Reconnecting DC-Input Power Supply Unit (on page 4-18)

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 130 131

Sin comentarios

Cisco Systems OL-7821-04 Manual de usuario Pagina 57