Cisco Systems PLSK400 Manual de usuario descargar pdf (Pagina 35)

Getting Started

PLEK400/PLSK400 Powerline Network Adapter

Installing the Powerline Network

Installation overview

To set up your Powerline network, you should:

• Make sure you already have Internet access and a working home network.

• Share Internet access with your Powerline network.

• Install Powerline adapters in each room where you want to connect a

wired network device.

Tips

• If possible, connect each Powerline adapter directly to a wall power

outlet, and not to an extension cord, power strip, or surge protector.

• If a Powerline adapter must be installed onto a power strip, make sure

that no other electronic devices are connected to the same power strip.

• For advanced adapter configuration, see “Advanced Configuration” on

page 6.

How to share Internet access

To share Internet access over the Powerline network, connect your router to

the Powerline network (typically with a single-port Powerline adapter such as

the PLE400).

To connect your wireless router to your Powerline network:

Connect your single-port Powerline adapter to a power outlet near your

wireless router. The adapter’s power LED turns on.

Use the included Ethernet network cable to the port on the adapter

and to an available port on the back of the wireless router. The adapter’s

Ethernet LED turns on. You are now ready to extend your Powerline

network to the rest of your home.

NOTE

For advanced security setup, see “Setting up advanced security” on

page 6.

NOTE: For advanced security, cross-ref.

How to add a Powerline adapter to your

network

After your existing network’s router is connected to a Powerline adapter, you

can add adapters elsewhere in your home.

To connect an additional Powerline adapter:

Connect the adapter to a power outlet near the network device(s) you

want to connect. The adapter’s power LED turns on. The Powerline LED

flashes, then stays on when the connection is finished.

Connect the network device’s network cable to an available port on the

Powerline adapter. The adapter’s Ethernet LED flashes, then stays on

when the connection is finished.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 119 120

Sin comentarios

Cisco Systems PLSK400 Manual de usuario Pagina 35