Cisco Systems MWAM Manual de usuario descargar pdf (Pagina 4)

6-4

Multiprocessor WAN Application Module User Guide

OL-4858-07

Chapter 6 Command Reference

Command Details

mwam module vlan-based

To assign MWAM traffic to a VLAN QoS policy, use the mwam module vlan-based command in global

configuration mode. To remove this configuration, use the no form of the command.

mwam module slot_number port port_number vlan-based

no mwam module slot_number port port_number vlan-based

Syntax Description

Defaults There are no default behavior or values.

Command Modes Global configuration.

Command History

Usage Guidelines Use this command to assign MWAM traffic to a VLAN QoS policy.

See Figure 1-1 and Table 1-1 to determine which port corresponds to each processor.

Examples The following example illustrates the mwam module vlan-based command:

Sup-7606(config)# mwam module 5 port 1 vlan-based

Sup-7606(config)# mwam module 5 port 2 vlan-based

Sup-7606(config)# mwam module 5 port 3 vlan-based

slot_number Specifies the slot that the module is plugged into.

port_number Specifies one of three switch fabric interface ports (1-3) that connect the

Supervisor module to the MWAM.

Release Modification

12.2(14)ZA7 This command was introduced.

1 2 3 4 5 6 7 8 9 ... 35 36

Sin comentarios

Cisco Systems MWAM Manual de usuario Pagina 4