Cisco Systems OL-25712-04 Manual de usuario descargar pdf (Pagina 617)

100

101

Renumbering a Chassis

You cannot renumber a blade server through Cisco UCS Manager. The ID assigned to a blade server is

determined by its physical slot in the chassis. To renumber a blade server, you must physically move the

server to a different slot in the chassis.

Note

Before You Begin

If you are swapping IDs between chassis, you must first decommission both chassis and then wait for the

chassis decommission FSM to complete before proceeding with the renumbering steps.

Procedure

Step 1

In the Navigation pane, click the Equipment tab.

Step 2

On the Equipment tab, expand Equipment > Chassis.

Step 3

Verify that the Chassis node does not include the following:

• The chassis you want to renumber

• A chassis with the number you want to use

If either of these chassis are listed in the Chassis node, decommission those chassis. You must wait until the

decommission FSM is complete and the chassis are not listed in the Chassis node before continuing. This

might take several minutes.

Step 4

On the Equipment tab, click the Chassis node.

Step 5

In the Work pane, click the Decommissioned tab.

Step 6

For the chassis that you want to renumber, do the following:

a) Right-click the chassis and choose Re-commission Chassis.

b) In the Chassis ID field of the Re-commission Chassis dialog box, type or use the arrows to choose the

ID that you want to assign to the chassis

c) Click OK

Step 7

If the Cisco UCS Manager GUI displays a confirmation dialog box, click Yes.

Cisco UCS Manager GUI Configuration Guide, Release 2.0

OL-25712-04 581

Renumbering a Chassis

1 2 ... 612 613 614 615 616 617 618 619 620 621 622 ... 767 768

Comentarios a estos manuales

Sin comentarios

Cisco Systems OL-25712-04 Manual de usuario Pagina 617

Comentarios a estos manuales