Cisco Systems WSC4500XF16SFP Manual de usuario descargar pdf (Pagina 112)

Chapter 3 Installing the Switch in a Rack

System Ground Connection Guidelines

3-22

Catalyst 4500 Series Switches Installation Guide

78-14409-08

Parts and Required Tools

Note Some parts and required tools described in this section are not available from

Cisco Systems. The grounding lug and associated screws are included with the

accessory kit.

To make an adequate grounding connection, you will need the following parts and

tools:

• Grounding lug—The grounding lug has two #10 AWG holes spaced 0.63 in

center to center. A Panduit LCDX6-10A-L or Pencom EL1033 lug may be

used if the lug from the accessory kit has been misplaced.

• Two M4 (metric) hex-head screws.

• One grounding wire (6 AWG recommended)—The length of the grounding

wires depends on the location of your switch within the site and its proximity

to proper grounding facilities.

• Number 2 Phillips screwdriver.

• Crimping tool—This tool must be large enough to accommodate the girth of

the grounding lug when you crimp the grounding cable into the lug.

• Wire-stripping tool.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 193 194

Sin comentarios

Cisco Systems WSC4500XF16SFP Manual de usuario Pagina 112