Cisco Systems ASR 1006 Guía de inicio rápido descargar pdf (Pagina 4)

Prepare for Rack-Mount Installation

Before you begin the rack-mounting tasks:

• Decide whether or not you want to front rack-mount or rear rack-mount the chassis

• Decide whether or not you want to attach cable-management brackets to your chassis.

Note If you install cable-management brackets, make certain that the chassis is installed in the equipment rack first.

• Decide if a two-post or four-post rack-mount will be used.

3 Rack-Mount the Router

This section provides information for rack-mounting the router.

Attach the Rack-Mount Brackets—Chassis Front-Mounted

To install the rack-mount brackets on a Cisco ASR 1006 Router for a front rack-mount configuration, follow these steps:

Step 1 Locate the threaded holes in the front sides of the chassis. Make certain that you hold the front rack-mount bracket

with the ear and holes facing outward and towards the front of the chassis.

Step 2 Align the rack-mount bracket to the side of the router. Depending on which set of rack-mount bracket holes you choose

to use to attach the rack-mount bracket to the router, the chassis will either be recessed in the rack or protrude from

the rack.

Step 3 Position the front rack-mount bracket top hole with the chassis first top hole behind the side vent holes as shown in

Figure 1Figure 1.

Figure 1 Cisco ASR 1006 Router Vent Hole Location and Front Rack-Mount Brackets

Chassis vent hole location

Front rack-mount bracket ear holes

Front rack-mount bracket

280093

Cisco ASR 1006

1 2 3 4 5 6 7 8 9 ... 43 44

Sin comentarios

Cisco Systems ASR 1006 Guía de inicio rápido Pagina 4