Cisco Systems CompactFlash Adapter Manual de instalación descargar pdf (Pagina 23)

Cisco CompactFlash Adapter for Bootflash Upgrade Installation Note

78-17277-04

Removing and Installing the CompactFlash in the CompactFlash Adapter

Figure 11 Removing the CompactFlash from the Adapter

To install the CompactFlash in the adapter, follow these steps:

Step 1 Remove the replacement CompactFlash from its packaging.

Step 2 Grasp the empty adapter and the CompactFlash, and position the CompactFlash in front of the adapter

as shown in Figure 12, View 1. Align the slots in the CompactFlash with the rails in the adapter.

Step 3 Slide the CompactFlash into the adapter until the CompactFlash is firmly seated in the adapter connector.

(See Figure 12, Views 2 and 3.)

Note To make good electrical contact, you must fully insert the adapter’s connector pins into the

CompactFlash; the pins should not be visible.

Step 4 Install the CompactFlash adapter in the DIMM socket using Step 6 and Step 7 on Page 15.

Step 5 Reinstall the Supervisor Engine 720 in the chassis following the “Reinstalling the Supervisor Engine

720” procedure on page 16.

144747

Cisco Systems

1 2 3

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Sin comentarios

Cisco Systems CompactFlash Adapter Manual de instalación Pagina 23