Cisco Systems IGX 8400 Series Guía de usuario descargar pdf (Pagina 13)

Card Installation and Node Startup 3-13

Setting Up a UXM-E

Removing Links from an IMA Feeder Group

To removelinks from an IMA group, you can use either Cisco WAN Manager or the CLI. To remove

a link from an IMA group on the CLI:

Step 1 Find the nodes conﬁgured as trunks connected to the IMA feeder by using the dsptrks

command.

Step 2 Reduce the number of retained links on the IMA feeder node.

Step 3 Reduce the receive rate using the DS0 calculation on the IMA feeder node.

Step 4 Repeat steps 2 and 3 on the IMA trunk.

Step 5 Reduce the number of IMA group members on both trunk and feeder nodes by manually

entering the number of group members. Enter:

cnftrk slot.primary link

Note The primary link cannot be removed from an IMA group.

UXM-E Inverse Multiplexing ATM IMA Lines

This feature allows the extensionof the IMA protocol to UXM-E line interfaces, which substantially

reduces equipment and interface costs for customers requiring IMA line interfaces and trunks and

high bandwidth demand for ATM. It reduces costs by bundling multiple physical T1/E1 lines into a

logical line enlarging trafﬁc bandwidth. This makes it unnecessary to upgrade access lines to higher

speed services such as T3/E3.

Note Both ends of the UXM-E IMA lines require you to install UXM-E Firmware Model B

(Release 9.2 and later SWSW). If the UXM IMA line is connected to another device, that device

must support ATM Forum Compliant IMA protocol, Version 1.0. To verify the UXM ﬁrmware

version, use the dspcd command.

To specify the range of ports for an IMA line, you can use either Cisco WAN Manager or the

command-line interface (CLI). To deﬁne an IMA line on the CLI, use the upln command:

upln slot.group-member

For example, you could enter upln 8.1–4. Subsequently, you would refer to this physical line by

using only the slot number and ﬁrstgroup member—8.1 in this example—whenyou use commands,

such as upln, dnln, cnﬂn, and so on. Following the activation of an IMA line group, the logical port

will be created with the primary line port as the port number.

Commands for viewing IMA line information also include dsplncnf, dsplns, dspports, dspport,

dspphyslnstathist and dspphyslnstatcnf.

Note The UXM-E IMA ports on an IGX, will interoperate with an IMA compliant router or a

device that supports the ATM Forum Compliant IMA Protocol, Version 1.0.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Sin comentarios

Cisco Systems IGX 8400 Series Guía de usuario Pagina 13