Cisco Systems Network Cabling Manual de usuario descargar pdf (Pagina 3)

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE 18

Table 1 shows how each port is used on the switch and control node.

Table 1 Description of Panel and Main Board Notation

Notation Description

ISL-1 Used to create the first half of interswitch link (ISL)

connection between the two Cisco switches.

ISL-2 Used to create the second half of the ISL connection

between the two Cisco switches.

GW-1 Used to create the first connection from the Cisco switch

to the gateway.

GW-2 Used to create the second connection from the Cisco

switch to the gateway.

C1-1 Used to connect the first control node’s first onboard

Gigabit Ethernet connection (Gb 1) into the Cassatt Active

Response environment through the designated switch port.

C1-2 Used to connect the first control node’s first onboard

Gigabit Ethernet connection (Gb 2) into the Cassatt Active

Response environment through the designated switch port.

C2-1 Used to connect the second control node’s second onboard

Gigabit Ethernet connection (Gb 2) into the Cassatt Active

Response environment through the designated switch port.

C2-2 Used to connect the second control node’s second onboard

Gigabit Ethernet connection (Gb 2) into the Cassatt Active

Response environment through the designated switch port.

C1-P Used to connect the first control node remote management

controller into the Cassatt Active Response environment.

C2-P Used to connect the second control node remote

management controller into the Cassatt Active Response

environment.

N1-1 through N23-1 Used to connect application nodes into the Cassatt Active

Response environment.

N2-1 through N23-2 Used to connect application nodes into the Cassatt Active

Response environment.

1 2 3 4 5 6 7 8 ... 17 18

Sin comentarios

Cisco Systems Network Cabling Manual de usuario Pagina 3