Cisco Systems PA-4T Manual de usuario descargar pdf (Pagina 70)

Checking the Configuration

PA-4T+ Synchronous Serial Port Adapter Installation and Configuration8-16

The following example of the show interfaces serial slot/port command on a Cisco 7200 series,

Cisco uBR7200 series, or Cisco 7100 series router shows all of the information speciﬁc to the ﬁrst

PA-4T+ interface port (interface port 0) in port adapter slot 1:

Router# show interfaces serial 1/0

Serial1/0 is up, line protocol is up

Hardware is M4T

Internet address is 10.10.10.1

MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255

Encapsulation PPP, loopback not set, keepalive set (10 sec)

LCP Open

Open: ipcp

Last input 00:00:09, output 00:00:09, output hang never

Last clearing of “show interface” counters never

Input queue: 0/75/0 (size/max/drops); Total output drops: 0

Queueing strategy: weighted fair

Output queue: 0/64/0 (size/threshold/drops)

Conversations 0/1 (active/max active)

Reserved Conversations 0/0 (allocated/max allocated)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

1675 packets input, 26792 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

1676 packets output, 26806 bytes, 0 underruns

0 output errors, 0 collisions, 3 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions DCD=up DSR=up DTR=up RTS=up CTS=up

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 76

Sin comentarios

Cisco Systems PA-4T Manual de usuario Pagina 70