Cisco Systems PA-4T Manual de usuario descargar pdf (Pagina 74)

Checking the Configuration

PA-4T+ Synchronous Serial Port Adapter Installation and Configuration8-20

The show version (or show hardware) command displays the conﬁguration of the system hardware

(the number of each interface processor type installed), the software version, the names and sources

of conﬁguration ﬁles, and the boot images. Following is an example of the show version command

used with a Cisco 7500 series router:

Router# show version

Cisco Internetwork Operating System Software

IOS (tm) GS Software (image-name), Version 11.1(8)CA, RELEASED SOFTWARE

Synced to mainline version: 11.1(8)

Compiled Thu 23-Jan-97 18:14 by bellb

Image text-base: 0x60010900, data-base: 0x609EE000

ROM: System Bootstrap, Version 11.5 [kmac 3.2], RELEASED SOFTWARE

ROM: GS Software (image-name), Released version 11.1(5) [sglee 112]

GEN1 uptime is 2 minutes

System restarted by reload

System image file is “image-name”, booted via tftp from 10.10.10.1

cisco RSP2 (R4600) processor with 32768K bytes of memory.

R4600 processor, Implementation 32, Revision 2.0

Last reset from power-on

G.703/E1 software, Version 1.0.

Bridging software.

X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.

Chassis Interface.

1 VIP2 controller (4 Ethernet)(4 Serial).

4 Ethernet/IEEE 802.3 interfaces.

4 Network Serial interfaces.

125K bytes of non-volatile configuration memory.

16384K bytes of Flash PCMCIA card at slot 1 (Sector size 128K).

8192K bytes of Flash internal SIMM (Sector size 256K).

Configuration register is 0x0

1 2 ... 69 70 71 72 73 74 75 76

Sin comentarios

Cisco Systems PA-4T Manual de usuario Pagina 74