
3
Installing Hard Disk Drives in the Cisco Wide Area Application Engine 611
78-17404-01
Introduction
Introduction
The WAE-611 supports two 1-inch (2.54-cm) slim 3.5-inch (8.89-cm) low voltage differential (LVD)
hard disk drives. The WAE-611 requires SCSI hard disk drives.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Required Tools
The following tools are required to perform the hard disk drive installation:
• Antistatic mat or foam pad to support and protect the removed hard disk drive
• Your own ESD-prevention equipment or the disposable grounding wrist strap included with all
upgrade kits, field-replaceable units (FRUs), and spares
Caution Always use an ESD wrist strap when handling modules or coming into contact with internal components.
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement
1029
Warning
The safety cover is an integral part of the product. Do not operate the unit without the safety cover
installed. Operating the unit without the cover in place will invalidate the safety approvals and pose
a risk of fire and electrical hazards.
Statement 117
Related Documentation
Use this publication in conjunction with the following hardware documentation:.
• Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide
• Regulatory Compliance and Safety Information for the Cisco Content Networking Product Series
Note To access these publications on Cisco.com, see the “Obtaining Documentation” section on page 10.
Comentarios a estos manuales