Cisco Systems SMNMADPTR Manual de usuario descargar pdf (Pagina 14)

Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0

OL-14942-02

How to Install, Upgrade, or Downgrade NME-NAM-120S

http://www.cisco.com/cgi-bin/tablebuild.pl/nme-nam

b. Locate the following file:

• nam-app.4.0.bin.gz

NME-NAM-120S Application Image Release 4.0 for Cisco Branch Routers

Note Most URL links are not usable during Early Field Trial.

c. Download the files to one of the following locations:

• FTP file server

• HTTP server

Step 2 Reset the system:

Router> enable

Router# service-module integrated-service-engine slot/0 reload

Step 3 Session into the NME-NAM-120S console.

ServiceEngine boot-loader> service-module integrated-service-engine slot/0 session

While the service module reboots, it displays the following prompt:

Enter *** to change boot configuration:

Step 4 Enter *** to go to the bootloader.

After you enter ***, you will be at the bootloader prompt. From this prompt, you can either boot the

NAM helper located at a TFTP server or boot the pre-installed helper image in the NAM flash.

–

To boot the NAM helper image from a TFTP server, do Steps 5, 6, and 7. Skip Step 8, then do

Steps 9, 10, and 11.

–

To boot the pre-installed helper image on the NAM compact flash, skip Steps 5, 6, and 7, then

do Steps 8 through 11.

Step 5 Configure the bootloader to load and launch the helper:

ServiceEngine bootloader> config

Prompts for the following appear in the order listed. For each, enter a value or accept the previously

stored input that appears inside square brackets by pressing Enter.

• NME-NAM-120S IP address and subnet mask

• TFTP file-server IP address

• Default gateway of NME-NAM-120S (normally the IP address for the ISR)

• Default helper image filename

• Ethernet interface: internal or external of NME-NAM-120S

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 57 58

Sin comentarios

Cisco Systems SMNMADPTR Manual de usuario Pagina 14