Cisco Systems VIP-FE-TX/4E Guía de usuario descargar pdf (Pagina 49)

VIP-FE-TX/4E Installation and Configuration 49

VIP Port Adapter Functions

Attaching 4E Port Adapter Interface Cables

On a single 4E port adapter, you can use up to four RJ-45 connections.

Note RJ-45 cables are not available from Cisco Systems; they are available from outside

commercial cable vendors.

Connect RJ-45 cables to the 4E port adapter as follows:

Step 1 Attach the Category 5 UTP cable directly to the RJ-45 port on the 4E port adapter. (See

Figure 29.)

The 4E port adapter is an end station device and not a repeater. You must connect the 4E

port adapter to a repeater or hub.

Figure 29 Connecting 4E RJ-45 Cables (Horizontal Orientation—Shown without Handles)

Note VIP conﬁgurations using only one 4E port adapter and a port adapter blank, or two 4E port

adapters, are currently not supported. The FE-TX and 4E port adapters have a handle attached, but

this handle is not shown to allow a full view of detail on each port adapter’s faceplate.

H4713

ETHERNET-10BT

LINK

RJ-45 cable (up to four)

To transceiver,

repeater, or DTE

FAST ETHERNET

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 57 58

Sin comentarios

Cisco Systems VIP-FE-TX/4E Guía de usuario Pagina 49