Cisco Systems ONS 15310-CL Guía para resolver problemas descargar pdf (Pagina 50)

1-16

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0

Chapter 1 General Troubleshooting

1.3.2 Perform a Cross-Connect Loopback on the Source OC-N Port

Create the Cross-Connect Loopback on the Source OC-N Port

Step 1 Connect an optical test set to the port you are testing:

a. If you just completed the “1.3.1 Perform a Facility Loopback on a Source-Node OC-N Port”

procedure on page 1-14, leave the optical test set connected to the OC-N port in the source node.

b. If you are starting the current procedure without the optical test set connected to the OC-N port, use

appropriate cabling to attach the Tx and Rx terminals of the optical test set to the port you are

testing.

c. Adjust the test set accordingly.

Step 2 Use CTC to put the circuit being tested out of service:

a. In node view, click the Circuits tab.

b. Click the circuit and then click Edit.

c. In the Edit Circuit dialog box, click the State tab.

d. Choose OOS-MT from the Target Circuit Admin State drop-down list.

e. Click Apply.

f. Click Yes in the confirmation dialog box.

Step 3 Use CTC to set up the cross-connect loopback on the circuit being tested:

a. In node view, double-click the 15310-CL-CTX or CTX2500 to open the card view.

b. For the OC-N port, click the Maintenance > Optical > Loopback > SONET STS tabs.

c. Click the check box in the XC Loopback column for the port being tested.

d. Click Apply.

e. Click Yes in the confirmation dialog box.

Step 4 Continue with the “Test the Cross-Connect Loopback Circuit” procedure on page 1-16.

Test the Cross-Connect Loopback Circuit

Step 1 If the test set is not already sending traffic, send test traffic on the loopback circuit.

Step 2 Examine the test traffic received by the test set. Look for errors or any other signal information that the

test set is capable of indicating.

Step 3 If the test set indicates a good circuit, no further testing is necessary with the cross-connect. Clear the

cross-connect loopback:

a. In card view, click the Maintenance > Optical > Loopback > SONET STS tabs.

b. Uncheck the check box in the XC Loopback column for the circuit being tested.

c. Click Apply.

d. Click Yes in the confirmation dialog box.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 333 334

Sin comentarios

Cisco Systems ONS 15310-CL Guía para resolver problemas Pagina 50