Cisco Systems SF300-24P Manual de usuario descargar pdf (Pagina 212)

100

101

VLAN Management

VLAN Groups

195 Cisco Small Business 300 Series Managed Switch Administration Guide

GVRP must be activated globally as well as on each port. When it is activated, it

transmits and receives GARP Packet Data Units (GPDUs). VLANs that are defined

but not active are not propagated. To propagate the VLAN, it must be up on at least

one port.

By default, GVRP is disabled globally and on ports.

Defining GVRP Settings

To define GVRP settings for an interface:

STEP 1 Click VLAN Management > GVRP Settings.

STEP 2 Select GVRP Global Status to enable GVRP globally.

STEP 3 Click Apply to set the global GVRP status.

STEP 4 Select an interface type (Port or LAG), and click Go to display all interfaces of that

type.

STEP 5 To define GVRP settings for a port, select it, and click Edit.

STEP 6 Enter the values for the following fields:

• Interface—Select the interface (Port or LAG) to be edited.

• GVRP State—Select to enable GVRP on this interface.

• Dynamic VLAN Creation—Select to enable Dynamic VLAN Creation on this

interface.

• GVRP Registration—Select to enable VLAN Registration using GVRP on

this interface.

STEP 7 Click Apply. GVRP settings are modified, and written to the Running Configuration

file.

VLAN Groups

VLAN groups are used for load balancing of traffic on a Layer 2 network.

Packets are assigned a VLAN according to various classifications that have been

configured (such as VLAN groups).

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 482 483

Comentarios a estos manuales

Sin comentarios

Cisco Systems SF300-24P Manual de usuario Pagina 212

Comentarios a estos manuales

Relacionado con productos y manuales para Software Cisco Systems SF300-24P