Cisco Systems SF300-24P Manual de usuario descargar pdf (Pagina 456)

100

101

Quality of Service

QoS Advanced Mode

439 Cisco Small Business 300 Series Managed Switch Administration Guide

If the new value (0..7) is a CoS/802.1p priority, use the priority value and

the CoS/802.1p to Queue Table to determine the egress queue of all the

matching packets.

If the new value (0..63) is a DSCP, use the new DSCP and the DSCP to

Queue Table to determine the egress queue of the matching IP packets.

Otherwise, use the new value (1..8) as the egress queue number for all the

matching packets.

• Police Type—Available in Layer 2 system mode only. Select the policer type

for the policy. The options are:

- None—No policy is used.

- Single—The policer for the policy is a single policer.

- Aggregate—The policer for the policy is an aggregate policer.

• Aggregate Policer—Available in Layer 2 system mode only. If Police Type

is Aggregate, select a previously-defined (in the Aggregate Policer page)

aggregate policer.

If Police Type is Single, enter the following QoS parameters:

• Ingress Committed Information Rate (CIR)—Enter the CIR in Kbps. See a

description of this in the Bandwidth page.

• Ingress Committed Burst Size (CBS)—Enter the CBS in bytes. See a

description of this in the Bandwidth page.

• Exceed Action—Select the action assigned to incoming packets exceeding

the CIR. The options are:

- None—No action.

- Drop—Packets exceeding the defined CIR value are dropped.

- Out of Profile DSCP—IP packets exceeding the defined CIR are

forwarding with a new DSCP derived from the Out Of Profile DSCP

Mapping Table.

STEP 5 Click Apply.

1 2 ... 451 452 453 454 455 456 457 458 459 460 461 ... 482 483

Comentarios a estos manuales

Sin comentarios

Cisco Systems SF300-24P Manual de usuario Pagina 456

Comentarios a estos manuales

Relacionado con productos y manuales para Software Cisco Systems SF300-24P