Cisco Systems Network Device 2800 Manual de instalación Pagina 161

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 186
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 160
33
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
OL-5792-04
Replacing the Power Supply
Figure 32 Inserting the ILP Supply into the Cisco 2801 Router
Step 6
Insert the screws that fasten the ILP supply to the chassis.
Step 7 Connect the main power supply cable to the main power supply connector, and connect the ILP supply
cable to the ILP supply connector.
Step 8 Verify that the vent blocking plate has been removed in Step 4. The ILP fans should be visible through
the vents that were blocked by the vent blocking plate.
Installing a Power Supply in a Cisco 2811 Router
Three types of power supplies are available for the Cisco 2811 router:
An AC-input power supply, driven by external AC power
A DC-input power supply, driven by external DC power
An inline power (ILP) supply, driven by external AC power. This supply provides power for the
router and inline power for a complement of IP phones attached to the router.
The following sections describe how to install each type of power supply.
Removing the Existing Power Supply, page 34
Installing an AC-Input Power Supply, page 36
Installing a DC-Input Power Supply, page 38
Installing an ILP Supply, page 40
1 ILP supply fastening screws 3 ILP connector
2 ILP supply 4 Main power connector
103060
1
4
3
2
Vista de pagina 160
1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 185 186

Comentarios a estos manuales

Sin comentarios