Cisco Systems 4/8xFE Guía de usuario descargar pdf (Pagina 110)

Chapter 7 Basic SCE 2000 Platform Operations

Displaying the System Uptime

Cisco SCE 2000 4/8xFE Installation and Configuration Guide

7-10 OL-7826-05

Displaying the System Uptime

Use this command to see how long the system has been running since the last reboot.

To show the system uptime for the SCE platform, use the following command:

At the SCE 2000# prompt, type show system-uptime and press Enter.

The system shows how long the system has been running since the last reboot.

EXAMPLE:

The following example shows how to display the system uptime of the SCE platform.

SCE 2000#show system-uptime

SCE 2000 uptime is 21 minutes, 37 seconds

SCE 2000#

Rebooting and Shutting Down the SCE Platform

Rebooting the SCE Platform

Rebooting the SCE platform is required after installing a new firmware, in order for that firmware

to take effect. There might be other occasions where rebooting the SCE platform is necessary.

Note

When the SCE restarts, it loads the startup configuration, so all changes made in the running

configuration will be lost. You are advised to save the running configuration before performing reload,

as described in Saving the Configuration Settings (on page 7-5).

To reboot your SCE platform, complete the following steps:

Step 1 At the SCE 2000# prompt, type reload and press Enter.

A confirmation message appears.

Step 2 Type Y to confirm the reboot request and press Enter.

EXAMPLE:

The following example shows the commands for system reboot.

SCE 2000# reload

Are you sure? y

the system is about to reboot, this will end your CLI session

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 130 131

Sin comentarios

Cisco Systems 4/8xFE Guía de usuario Pagina 110