Cisco Systems PGW 2200 Guía de usuario Pagina 188

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 436
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 187
4-6
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 4 Configuring the Cisco PGW 2200 Softswitch Software
Initial Cisco PGW 2200 Softswitch Software Configuration
*.SysConnectDataAccess Controls whether data access is enabled or disabled (if
the engine attempts to connect to the MMDB or to call
screening database at startup).
Val u es :
true = connect to MMDB or call screening
database
false = do not connect to MMDB or call screening
database
Default: false
Note This parameter must be set to true in calling
scenarios where Euro-LNP, A Number
Screening, or other features requiring real time
database access are required. Otherwise, it can
remain false for an increase in the available
system memory usable for call processing.
*.TCAP.avgInvokePerDialog Specifies the maximum number of outgoing Invoke
messages per dialog.
Values: 1-10
Default: 1
*.TCAP.maxSsnNum Specifies the maximum number of local Subsystem
Numbers (SSNs) supported by the
Cisco PGW 2200 Softswitch.
Values: 1-10
Default: 1
*.transpathId A unique number that identifies each virtual switch
controller within the ASN (Auxiliary Signaling
Network).
Default: 01
*.Virtual_IP_Addr1 through
*.Virtual_IP_Addr2
Specify virtual IP addresses for the
Cisco PGW 2200 Softswitch that are used for SIP
Failover Support.
Table 4-3 Configuration Parameters (continued)
Parameter Description
Vista de pagina 187
1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 435 436

Comentarios a estos manuales

Sin comentarios