Cisco Systems PGW 2200 Guía de usuario Pagina 250
- Pagina / 436
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
4-68
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 4 Configuring the Cisco PGW 2200 Softswitch Software
Configuring SCP Queries
###################
$OperationReceiving
###################
#
# F1 F2 F3 F4 F5 F6
# componentType opClass opCodeFamily opCodeSpecifier opCodeFlag PR
#----------------------------------------------------------------------
# OR 1: Customer 1 LNP / Generic LNP
#----------------------------------------------------------------------
6 1 101 1 4 1
#----------------------------------------------------------------------
# OR 2: Genesys 800 (Result)
#----------------------------------------------------------------------
1 1 0 20 1 2
#----------------------------------------------------------------------
# OR 3: Genesys 800 (Error)
#----------------------------------------------------------------------
3 1 0 0 1 3
#----------------------------------------------------------------------
# OR 4: ANSI AIN 800
#----------------------------------------------------------------------
6 1 101 1 4 4
#----------------------------------------------------------------------
# OR 5: ANSI AIN 800 Request for status notification
#----------------------------------------------------------------------
6 1 103 5 4 5
#----------------------------------------------------------------------
# OR 6: ANSI PRE AIN 800
#----------------------------------------------------------------------
6 1 4 1 3 6
#----------------------------------------------------------------------
# OR 7: ANSI PRE AIN 800 Request for status notification
#----------------------------------------------------------------------
6 1 6 1 4 7
#----------------------------------------------------------------------
# OR 8: CS1/INAP Based CLI Screening Connect Operation
#----------------------------------------------------------------------
1 1 0 20 1 8
#----------------------------------------------------------------------
# OR 9: CS1/INAP Based CLI Screening ConnectToResource Operation
#----------------------------------------------------------------------
1 1 0 19 1 0
#----------------------------------------------------------------------
# OR 10: CS1/INAP Based CLI Screening PlayAnouncement Operation
#----------------------------------------------------------------------
1 1 0 47 1 9
#----------------------------------------------------------------------
# OR 11: INAP Free Phone, LNP & Carrier Pre-Selection Services Connect Operation
#----------------------------------------------------------------------
1 1 0 20 1 10
#----------------------------------------------------------------------
# OR 12: INAP LNP for Norway, Expected Response (Connect)
- Text Part Number: OL-18083-01 1
- CONTENTS 3
- Contents 4
- Document Objectives 9
- Audience 9
- Related Documentation 9
- Document Change History 10
- Installation 11
- Required Software Media 12
- Minimum System Requirements 12
- Required Tasks 13
- Table 1-4 Tasks Checklist 14
- Supported Platforms 15
- Supported Disk Drives 15
- Before You Start 16
- - Selecting package (SUNWifp) 20
- Host” section on page 2-50 26
- 89 blocks 34
- 426 blocks 34
- 8 blocks 34
- SUNWnfscr 43
- SUNWkrbr 43
- /devices-/devicesdevfs-no 45
- Configuring Your Host 64
- SUNWnfscr 85
- SUNWnisu 85
- DO NOT REBOOT 100
- OL-18083-01 104
- (CSCOh026) 117
- Using the SunVTS Test Package 145
- Normal Unit Test 145
- Running a Test in Brief Mode 149
- Running a Test in Full Mode 150
- Manager (ILOM) 152
- Figure 2-1 System Agreement 153
- Figure 2-4 LOM Screen 154
- Start ILOM Using Secure HTTP 157
- An Example of Using ILOM 161
- Serial Console ttya 162
- Cautions, Notes, and Tips 166
- Enter y and press Enter 169
- Enabling Sudo 179
- Installing the License File 179
- Software 183
- Software Directory Structure 185
- % MGC_Setup 190
- Configuring Groups and Users 193
- Basic Tasks 196
- Deleting an SNMP COMMUNITY 201
- Adding a Trap Destination 202
- Deleting a Trap Destination 204
- Activating the New Settings 205
- Specifying IP Addresses 212
- Configuring Engine Parameters 214
- Setting the Call Cutoff Timer 216
- Enabling Call Screening 216
- Configuring Switchover 221
- Configuring SCP Queries 224
- Sample trigger.dat File 227
- .odbc.ini File Information 265
- Setting Up Replication 265
- Network Requirements 266
- Synchronizing Databases 270
- Configuring Cisco ITP-Ls 271
- Configuring the Data Dumper 272
- Migrating to Solaris 10 and 275
- Release 9.8 275
- Cautions and Notes 276
- Required Software 277
- License Installation 277
- Recording System Data 277
- Migration Overview 278
- Installing Sun Solaris 10 282
- Restoring Data Files 283
- Platforms 295
- Live Upgrade Procedure 296
- Falling Back Overview 300
- Release 9.5 or 9.6 301
- Backup Procedure 308
- Restoring the System 309
- LAN Switch Overview 311
- Catalyst 2900 XL Series 312
- Catalyst 5500 and 5000 Series 312
- XECfgParm.dat File Parameters 313
- Special Parameters 314
- Relationships 359
- HP OpenView 363
- Formatting Trap Messages 365
- Step 8 Close the window 366
- Sample Installation Scripts 367
- Sample Uninstall Scripts 413
- Sample LAN Configurations 421
Relacionado con productos y manuales para Software Cisco Systems PGW 2200
Software Cisco Systems OL-5532-02 Manual de usuario
(32 paginas)
(32 paginas)
Software Cisco Systems 2200 Manual de usuario
(134 paginas)
(134 paginas)
Software Cisco Systems QC-29 Manual de usuario
(24 paginas)
(24 paginas)
Software Cisco Systems OL-25712-04 Manual de usuario
(768 paginas)
(768 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.102 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales