Cisco Systems PGW 2200 Guía de usuario descargar pdf (Pagina 284)

5-10

Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide

OL-18083-01

Chapter 5 Migrating to Solaris 10 and Cisco PGW 2200 Softswitch Software Release 9.8

Migration from Release 9.5 or 9.6 to Release 9.8 without Platform Changes

Step 1 Install the Cisco PGW 2200 Softswitch software using the instructions in the “Installing the

Cisco PGW 2200 Softswitch Software Release 9.8 and Higher Releases” section on page 3-3.

Step 2 When the installation is complete, perform the following steps on PGW host 2:

Step 3 Log into PGW host 2 as mgcusr.

Step 4 Enter the following command to start the Cisco PGW 2200 Softswitch software on PGW host 2:

% sudo /etc/init.d/CiscoMGC start

Step 5 If you are migrating from the Sparc platform to the Opteron platform, start a provisioning session and

regenerate the .bin files:

mml> prov-sta

mml> prov-cpy

Caution Complete this step only if you are migrating from the Sparc platform to the Opteron platform.

Step 6 Verify that the migration to the Cisco PGW 2200 Softswitch software Release 9.8 is complete and that

all protocols are operational:

mml> rtrv-ne

mml> rtrv-tc:all

mml> rtrv-dest:all

mml> rtrv-c7lnk:all

mml> rtrv-iplnk:all

Step 7 Enter the following command on the standby host to verify that call replication is occurring between

PGW hosts 1 and 2:

mml> rtrv-tc:all

----------rtrv-tt-database--------

# numan-rtrv:cliprefix:clisetname="1111",cliprefix="1"

# numan-rtrv:announcement:annId=1,gwtype="AS5400"

# numan-rtrv:porttbl:digitstring="100034"

Step 8 You have now upgraded the PGW host 2 to the Release 9.8 software. Promote PGW host 2 to active:

Note This step sets PGW host 1 to standby.

mml> sw-over::confirm

Step 9 When the switchover is complete, verify that PGW host 2 is processing calls.

mml> rtrv-tc:all

Note If the call replication fails, or if new active host is not processing calls, see the

Cisco PGW 2200 Softswitch Release 9 Operations, Maintenance, and Troubleshooting Guide.

Migrating the First Cisco PGW 2200 Softswitch Software to Release 9.8

Use the steps in the following sections to upgrade PGW 1 to Cisco PGW 2200 Softswitch Release 9.8.

1 2 ... 279 280 281 282 283 284 285 286 287 288 289 ... 435 436

Sin comentarios

Cisco Systems PGW 2200 Guía de usuario Pagina 284