Cisco Systems PGW 2200 Guía de usuario descargar pdf (Pagina 204)

4-22

Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide

OL-18083-01

Chapter 4 Configuring the Cisco PGW 2200 Softswitch Software

Configuring SNMP Support Resources

• Verifying the SNMP Configuration Migration, page 4-24

The procedure for adding a Trap Destination is now complete. Proceed to the selection you entered in

the SNMPD Configuration Main Menu.

Deleting a Trap Destination

From the SNMPD Configuration Main Menu:

Step 1 To delete a Trap Destination, enter 5 (Delete a Trap Destination):

Text similar to the following is displayed:

=================== Delete Trap Menu ===================

1. TargetAddress: 7.7.7.7:0 , TargetAddrParams: v1ExampleParams ,

IP Mask: 255.255.255.255:0

2. TargetAddress: 6.6.6.6:0 , TargetAddrParams: v1ExampleParams ,

IP Mask: 255.255.255.255:0

Would you like to proceed with the Delete [n]/[y]?

Step 2 Enter y to delete a Trap Destination (if you enter n to cancel the deletion, you return to the SNMPD

Configuration Main Menu):

Text similar to the following is displayed:

Enter a selection (1 through 2):

Note The Target Addresses (1 through 2) shown above are examples only.

Step 3 Enter 1 to select the TargetAddress to be deleted:

Text similar to the following is displayed:

Trap is about to be deleted. Are you sure that you want to delete this Trap Entry

[n]/[y]?

Step 4 Enter y to confirm the deletion (if you enter n to cancel the deletion, you return to the SNMPD

Configuration Main Menu).

Text confirming the deleted Trap Entry is displayed and you are returned to the SNMPD Configuration

Main Menu. Note that 483 (below) is an internal Trap snmpTargetAddrName.

Deleting Trap snmpTargetAddrName = 483

=================== SNMPD Configuration Main Menu ===================

1. View Configuration Entries

2. Add an SNMP Community

3. Delete an SNMP Community

4. Add a Trap Destination

5. Delete a Trap Destination

6. Activate the New Settings

Enter a selection (1 through 6) or 'q' to quit:

1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 435 436

Sin comentarios

Cisco Systems PGW 2200 Guía de usuario Pagina 204