Cisco Systems ATA 188 Guía de usuario Pagina 66

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 228
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 65
4-10
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (H.323)
OL-4008-01
Chapter 4 Basic and Additional H.323 Services
Additional H.323 Services
Configuring On-hook delay
This feature is available only for the recipient (callee) of a call. If the callee picks up the phone and then
later hangs up to retrieve another call, the hang-up is not considered on-hook until the specified delay
expires.
Related Parameter
Polarity, page 5-27—Bits 8 to 12
Configuring Reverse Audio Cut-Through Behavior
You can configure the reverse audio cut-through behavior of the Cisco ATA by using Bit 5 of the
ConnectMode parameter.
Related Configuration Parameter
ConnectMode, page 5-28
Configuring Supplementary Service Behavior and Parameters
Service providers can offer many supplementary services, which can be activated, configured, or
deactivated in more than one way.
The behavior and activation/deactivation of call supplementary services can be different from one
country to another. You can use the CallCmd parameter to define the behavior and the
activation/deactivation access code for the supplementary services that the Cisco ATA supports.
Related Configuration Parameter
CallCmd, page 5-46
Debugging Diagnostics
You can use the following parameter to troubleshoot operation issues:
NPrintf, page 5-35—Use this parameter to specify the IP address and port where debug information
is sent.
Hardware Information Display
Cisco ATA hardware information is displayed in the lower-left corner of the Cisco ATA Web
configuration page.
Vista de pagina 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 227 228

Comentarios a estos manuales

Sin comentarios